- 4 -
11f
11l
11f: Remove the lever unit.
11l: Before reassembling the rotor unit, smear a small
quantity of grease in the seats of the ball bearings.
11g
11m
11g: Utilising the tool shown in the figure, unscrew the
internal ring (12) in an anti-clockwise direction and
remove it.
11n
Remove the internal pad (19) from the pincer body and
clean it using a brush dipped in alcohol.
To clean the rotor unit it is necessary to remove the exter-
nal pad (18).
11n: After having substituted the rubber (11), reassem-
ble the lever unit taking care to insert the lever pin into
the hole of the counter-rotor.
Rotate the lever and position it as shown in the figure
keeping it pushed downwards.
Grease the pins of the adaptor (3) and reassemble the
remaining components proceeding in the reverse order
of removal.
11d
11d: Using a 4mm spanner, unscrew the screw (8) as
shown in the figure.
11e
11h
11h: Utilising pincers, slide out the rotor unit
11i
11i: Separate the rotor (15) from the counter-rotor (13)
and clean the components using a brush dipped in alco-
hol.
Reinsert the internal pad (19) and fix it with the metal
tongue (20) and the appropriate screw (21).
11m: Insert a 2.5mm spacer between the two pads.
Reinsert the rotor unit and fix it with the internal ring (12)
utilising the appropriate tool.
11e:
ATTENTION: Never disassemble the pincer
lever using tools.
ATTENTION: Be careful to not drop and lose
the internal ball bearings (14) of the rotor
unit.
ATTENTION: Be careful to reassemble the
rotor unit so that the teeth of the counter-
rotor coincide with an angle of the hexagon of the
rotor.
12
SUBSTITUTION OF THE BRAKE PADS
N.B.: The numbers in parentheses indicate the reference
of the parts in the exploded view.
12: Activa version
Remove the cable from the lever of the braking system
without unscrewing the cable grip.
Remove the pincer unit by slackening the fixing screws T.
13: Removal of the internal pad
Unscrew the screw U (21) utilising a 2.5mm hexagonal
spanner.
Straighten the safety tongue V (20) and remove the used
pads Z.
ATTENTION: Be careful when using the
screwdriver: the dimensions of the parts are
small and therefore this operation could cause
injuries to the hand. Wear protective gloves.
13
14: External pad removal
Bring the pommel Y (22) into the position where it is
touching the circlip.
Extract the plastic protection K.
Insert a small-bladed screwdriver (see figure) between
the pincer body J (24) and the support surface of the pad
W.
Apply a light pressure in the direction indicated by the
arrow and remove the worn out external pad.
Rotate the external pad adjustment pommel X (23) in an
anti-clockwise direction until it stops.
(7 strony)
(8 strony)
(106 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji